Multifunctional Sinter HIP Furnace with stable structure for stable sintering

Design description:

The vacuum sintering furnace for a single room, horizontal, intermittent heating, with low voltage large current graphite heating electric heating element, a heating unit, each unit individually controlled temperature; Have vacuum sintering, rapid cooling function, operation mode using push button control.Design criteria: two-door horizontal structure, horizontal structure designed to facilitate handling and maintenance, the entire process of manual controlSystem.It can meet the powder metallurgy process, the uniformity of furnace temperature uniformity and atmosphere of strict requirements. A reasonable furnace structure of advanced design, easy to use operation and maintenance. The main supporting components (sensors, graphite heater, thermocouple, main control valve, vacuum pump, etc.) with the current international advanced level, can adapt to long-term, stable and reliable mass production requirements. At the same time, the device should also meet the requirements of the state of energy saving, environmental protection.

Equipment color matching:
The surface of furnace body, transformer, control cabinet and vacuum pump is light gray(color code: RAL7035)；Furnace foot, pump frame, support for sky blue (color code: RAL5015)；
The wire groove is stainless steel, the support is galvanized, and the transformer is placed on the ground.

General requirement of equipment:
Mainly used for hard alloy dewaxing (Ar carrier gas dewaxing and continuous and pulse hydrogen micro-positive pressure dewaxing), vacuum sintering, pressure separation sintering, rapid cooling and other processes.The above process can be continuously treated.It can meet the strict requirements on furnace temperature uniformity and atmosphere uniformity of cemented carbide in its sintering process,the furnace structure design advanced and reasonable, easy to use operation and maintenance.The main supporting components (control components, sensors, graphite heater, thermocouple, main control valve, vacuum pump, etc.) have the international advanced level, can adapt to long-term, stable, reliable mass production requirements.At the same time, the equipment meets the national requirements of energy conservation and environmental protection.

Factory working environment:

After sales:

1.Installation, Commissioning And Acceptance

  We do installation, commissioning and acceptance in buyer's plant.During the installation and commissioning period, the commissioning personnel shall be provided free of charge by the demander according to the staff standard.

  The equipment shipped to the buyer, the seller received the buyer's notification, both within a week to carry the equipment out of the box together, then check the equipment and all components according to the packing list . Including equipment accessories, spare parts and special tools, attached manual and technical documents, etc. It can be installed after the acceptance check of equipment.
  After installation and debugging, the equipment shall be accepted according to the technical accessories.

2.Training

When taking-over the Furnace to the customer, We will give a staff training to customer. The operating personnel of the customer should join to commission,test the furnace, when installing at customer’s company.
This is practical operation training and practical maintenance training,
and our technical personnel will telling the basic principle,equipment maintenance knowledge,And the common fault handling measures.We can training 2 ~ 3 workers. ( Training how to maintenance and operating.)

3. Warranty period

The warranty period of the equipment is 12 months, which starts from the date of installation and debugging of the supplier. Equipment failure happens, after-sales service personnel shall give solutions within 2 hours, after receiving the buyer's notification . If it is need to go to the site for treatment , operators dispatched by seller should arrive at the site within 48 hours after go aboard. In case of emergency,operators should arrive at the site within 48 hours after go aboard, and continue to make repairs until the fault is removed and the equipment returns to normal.