Metal Sintering Furnace For Carbon-Sensitive Metal, Tungsten Alloy
This sintering furnace is applicable for and not limited to hard alloy products, high magnetic products, cermets products, ceramics products.
*Furnace body positive pressure leakage detection
*Furnace body negative pressure leakage detection
It including:continuous,intermittent and static.
*Electrical control system
*Cooling water system
*Rapid cooling system
- Valid working zone size:600mm × 600mm × 1200mm
- Maximum loading capacity:1500kg,it depends on the product type.
- Maximum design temperature:1300℃
- Working temperature:1200℃
- Heating mode: graphite rod resistance heating
- Temperature control mode:3 zone independence temperature control
- Vacuum rate: in the empty furnace, clean and cold state, the vacuum degree reaches 1x10-5 Torr (1.33x10-3 Pa) after starting the pump units for 60 minutes.
- Leakage rate:≤6.65X10-1 Pa/h(In the empty furnace, clean, cold state, within 24 hours of the average)
- Heating rate:5-10 ℃/min (full loading)
- Rapid cooling time:≤5h (Annealing temperature drops to 100℃)